Keraplan

Assembly

Worktops
Worktop series K10, N10, M10 and R10 are suitable for both benching and fume-cupboards. For bigger quantities, special sizes can be supplied as well. Each top can be supplied with sinks, drip cups and tap holes.

The characteristics of the tops:

• K10: standard tops with raised edge around
• N10: standard tops with raised edge around
• M10: tops with thickness of 20mm, without raised edge around
• MK10: tops with thickness of 20mm, with raised edge around

Combination worktops Keraplan worktops can be used in combination, to create larger benches. The worktops for benches are preferably to be ordered together, to get the best result with regard to flatness and colour. As ceramic is a natural product, dimensions and colour of the tops may vary slightly from each other.

To make a combination of K10 tops, it is possible to cut-off one or more edges, in a way that a large flat work-surface can be created, with only a raised upstand around the complete work-surface. These options are called P10.

Combination of K10 tops. The same combination with raised edge only around the complete bench can be made with P10 series	Combination of M10tops. Thin top (20 mm) without raised edge.

Assembly of Keraplan worktops
Use supporting inserts at the corners between tops and underlying (metal) structure. This inserts can be rubber or an adjustable screw.

Sinks
Sinks are normally supplied separately (not fixed under the tops), to reduce transport-costs and the risk of breakage during transport. However, if requested, the sinks can be fixed to the tops at the factory, at additional cost.
Two-component Epoxy resin is used for attaching the sinks to the tops. This can be bought locally, or ordered at the factory ("Kerapoxy glue"). Approximately half a kilogram is needed for one sink.